Wuhan UHV specializes in producing series resonance (also known as series resonance withstand voltage device). Next, we will share with you the conditions for generating resonance in series resonance parallel circuits. Do you know
In a series resonant system circuit consisting of resistors, capacitors, and inductors, the phenomenon of working power supply, voltage, and current being in phase information occurs, which is called knowledge series resonance. Its characteristics are: the circuit is purely resistive, the power supply, voltage, and current are in phase, the reactance X is equal to 0, and the impedance Z is equal to the absence of resistance R. At this time, the impedance of the control circuit has the smallest impact, and the current can be maximized. High voltages that are many times larger than the input voltage of the power supply may develop on the inductors and capacitors. Therefore, series resonance is also known as voltage resonance.
Parallel resonance refers to a circuit in which a resistor, capacitor, inductor, and parallel circuit exhibit the phase of terminal voltage and current, resulting in the superposition of parallel resonance voltage and original pressure. The characteristic of parallel resonance is that it completely compensates for this phenomenon, but does not provide reactive power from the power source. Active power only provides the required resistance, resonance, minimum total current circuit, and branch circuit current are often larger than the total current. Therefore, it is also known as parallel resonance current resonance.
The problem of series resonance is to connect the power supply and LC circuit in series. When XL=XC is satisfied, the LC equivalent impedance is almost zero, and the output voltage and current of the power supply system can be extremely large, so it is also known as "current resonance".
Current phenomena of series resonance and parallel resonance
1. When a series resonance occurs, the current in the circuit can be maximized.
2. When parallel resonance occurs, the current in the circuit is minimized.
Advantages of using a series resonance in power management systems:
1. The required power system capacity can be greatly reduced. The power supply generates high voltage and high current by utilizing the resonance problem between the resonant reactor and the tested capacitor. In the entire management system, the power supply only needs to provide the active consumption part of the information system. Therefore, the power output power required for experimental development is only 1/Q of the experimental data capacity.
2. Greatly reduced the weight and volume of the equipment. In series resonant power supply, not only does it eliminate the bulky high-power voltage regulation control device and ordinary high-power power frequency test research transformer, but also the resonant excitation power supply only needs to perform 1/Q of the test data capacity, which greatly increases and reduces the weight and volume of the information system structure, generally 1/10-1/30 of ordinary student test and detection devices.
3. Improve the waveform of the output working voltage of the enterprise. A resonant power supply is a resonant filtering circuit that can improve the waveform of the output voltage to obtain a good sine waveform, effectively preventing the erroneous breakdown of the sample by harmonic peaks.
4. Prevent large short circuits and calculate current burns to identify fault points. In the series resonance working state, when the weak point of the insulation of the test sample is broken down, the circuit can immediately de resonate, and the loop current rapidly decreases to 1/Q of the normal development test research current. However, in parallel resonance or conducting test research on the working mode of transformers for withstand voltage testing, the breakdown current can immediately start to rise by tens of times. Compared with the two, the short-circuit current and breakdown current differ by hundreds of times. Therefore, series resonance can effectively detect weak insulation links without worrying about large short-circuit currents burning out the fault point.
5. It will not cause any overvoltage without any recovery. When the test sample breaks down, due to the loss of resonance conditions, the high voltage immediately disappears, the arc immediately extinguishes, and the process of re establishing and developing the working voltage takes a long time. It is easy to disconnect the power supply before learning to reach the flashover voltage again. This system voltage recovery production process is an intermittent oscillation process with continuous energy accumulation, which is long and will not result in any economic recovery overvoltage.





