As current flows through circuit components, various modes may occur. The phase coincidence of current and voltage vectors in circuits with capacitors and inductors is called series resonance (also known as variable frequency series resonance) phenomenon.
With it, when X=I m ∙ Z, B=I m ∙ Y, R=Z, and φ=0, the reactance of the load disappears, and all relationships with active resistance are satisfied.
In electrical engineering, the series connection of inductive and capacitive load components may lead to voltage resonance. When resonance occurs at X=X L - X C=0, consider its performance for the simplest circuit with sequentially formed circuits. Represent X L=X C, and then substitute their expressions into the ratio:
![]()
When considering inductance and capacitance, the stress vectors are in opposite phases and cancel each other out. In this case, all voltages applied to the circuit will affect the active resistance. The vector diagram is represented as follows:

The graph shows that during resonance, the voltage at the reactive load may significantly exceed the input voltage of the circuit. To evaluate this parameter, the term Q factor of contour Q was introduced.
![]()
It depends on frequency, capacitance or inductance. You can adjust the quality factor by changing any of the listed parameters. In radio engineering, it has been widely used to increase its value to hundreds of units during series resonance.
In this case, the reactance and total resistance in the circuit will change, resulting in changes in the current, voltage, and phase angle at various power receivers.
The dependence of circuit parameters when changing the value of capacitor C O to generate resonance is shown in the following figure:

In a branch circuit, current resonance occurs when the reactive part of the current in the opposite branch points in the opposite direction and reaches equilibrium in magnitude. The total current in a circuit is formed by the sum of the active current components in the branches.





