
In a series RLC circuit, when the inductance value of the inductor is equal to the capacitance value of the capacitor, a frequency point appears, in other words, X large=X C. The point where this occurs is called the resonant frequency point, (ƒ - r), and as we are analyzing the series RLC circuit, this resonant frequency produces a series of resonant circuits.
As the frequency approaches infinity, the reactance of the inductor will also increase towards infinity, and the circuit components act like an open circuit. However, as the frequency approaches zero or DC, the reactance of the inductor will decrease to zero, causing the opposite effect, like a short circuit. This means that the reactance of the inductor is proportional to the frequency, smaller at low frequencies and higher at high frequencies.
The main difference between series resonance (also known as variable frequency series resonance test device) and parallel resonance is that due to the formation of energy storage circuits, there is a large amount of circulating current, and its direction following the series resonance current curve is exactly opposite.
When the frequency approaches infinity, the reactance of the capacitor will decrease to zero, causing the circuit components to operate like an ideal conductor of 0 Ω. However, as the frequency approaches zero or DC level, the reactance of the capacitor will rapidly increase to infinity, causing it to exert a large resistance effect like an open circuit state. For any given capacitance value, this means that the capacitance reactance is inversely proportional to the frequency.
When X L=X C, two equal and equal reactances cancel each other out. And the point where two reactance curves intersect in the figure indicates resonance in the AC circuit.

Please note that when the capacitance reactance dominates the circuit, the impedance curve itself has a hyperbolic shape. However, when the inductance reactance dominates the circuit, due to the linear response of X L, the curve is asymmetric. Therefore, if the circuit impedance is at its minimum value during resonance, the admittance of the circuit must be at its maximum value. One of the characteristics of a series resonant circuit is that the admittance is very high, but this may be a bad thing because the very low resistance value during resonance means that the circuit current may be very dangerous.

The frequency response curve of a series resonant circuit indicates that the magnitude of the current is a function of frequency. When plotted on a graph, it can be seen that the response starts from near zero and reaches its maximum resonant frequency at I MAX=I. R becomes infinite with ƒ and then decreases again to near zero. As a result, even at resonance, the amplitude of the voltage C across the inductor L and capacitor C can be much larger than the power supply voltage because they are equal and cancel each other out when they are opposite. Since the series resonant circuit only functions at the resonant frequency, this type of circuit is also called a receiver circuit because the impedance of the circuit is at its minimum during resonance, making it easy to accept a frequency equal to its resonant frequency. The current. The resonance effect in a series circuit is also known as "voltage resonance".





