Series Resonant RLC Circuit

Sep 23, 2025 Leave a message

news-288-262

The vector diagram of a series resonant (also known as variable frequency series resonant) RLC circuit shows the capacitive impedance (left), inductive impedance (center), and resistive impedance (right) during resonance. The voltage vector on the graph is composed of a right angled triangle with the hypotenuse V T, the vertical conduit V L V C, and the horizontal conduit V R. It can be seen that due to the capacitive nature of impedance, current precedes voltage, while inductance lags behind voltage.

 

6


In a series resonant RLC circuit, the same current flows through resistors, capacitors, and inductors, but the voltage drop across the circuit components is different. The vector diagram shows the voltage V T of an ideal voltage source. Due to the presence of resistance, this graph shows that the horizontal voltage vector across the resistor is in phase with the current flowing through the resistor. The inductance voltage vector V L is 90 ° behind the current vector, so it points upwards (+90 °). The voltage vector on the capacitor is 90 ° ahead of the current vector; Therefore, its direction is downward (-90 °). The vector sum of two vectors pointing in opposite directions can be directed downwards or upwards, depending on whether the voltage drop is greater on the inductor or capacitor. The total voltage vector in circuit VT is determined by the Pythagorean theorem.


At the resonant frequency, the capacitance and inductance are equal. If we look at the | Z | formula above, we will see that the effective impedance will be determined only by the resistance value and will be minimized. The same current flows through inductors and capacitors, and the voltage drop across them is equal and of opposite sign, because their reactance is also equal. Therefore, at the resonant frequency of the source, the current consumption is determined only by the resistance, as the ideal series LC circuit at resonance is a short circuit of the power supply. If there is resistance in the circuit, the series RLC circuit at resonance is a purely resistive load.


When determining the resonant frequency of a series RLC circuit, the following factors should be considered:

news-176-99


Multiplying both sides of the equation by the frequency f, we obtain:

news-145-73


If the two sides of the equation are divided by 2 π L, the square roots are extracted from both sides, and the resulting expression is simplified, the value of the resonant frequency can be obtained:

news-138-62

Send Inquiry

whatsapp

Phone

E-mail

Inquiry