Determine The Quality Factor Of A Series Resonant Circuit?

Sep 22, 2025 Leave a message

news-167-167

The Q factor of a series resonant (also known as a series resonant device) system is a quantity that characterizes the resonant characteristics of a linear resonator. The width of the resonance curve is numerically equal to the ratio of the resonance frequency w to the resonance frequency, with a time factor of Q=W/Δ W. It is also commonly expressed by the ratio of energy stored in the system, expressed as the average loss power P during the resonance period, Q = w W /P. However, in the presence of losses, the stored energy cannot be strictly determined, but is determined by conditionally distinguishing between dissipative and reactive elements. Therefore, for example, in the case of electricity. The stored energy is believed to be concentrated in pure reactive elements. Inductance L and capacitance C, and resistance R that is purely related to the flow of current as an energy consuming component

news-253-63


Resonant circuits are typically characterized by their Q-factor Q, which is defined as the value inversely proportional to the logarithmic attenuation:


It can be seen that the higher the quality factor of the circuit, the greater the number of resonances that need to be completed before the amplitude is reduced by e times.

 

352


In the case of weak attenuation

news-106-56


The Q factor is a characteristic of a series resonant system that determines the resonant band, indicating that the energy reserve in the system is greater than the number of times energy is lost in one resonant cycle.


The quality factor is inversely proportional to the attenuation rate of natural resonance in the system. That is, the higher the quality factor of the series resonant system, the smaller the energy loss per cycle, and the slower the damping of the resonance.


For example, in an electric resonant circuit, energy is dissipated due to the limited resistance of the circuit. In a quartz crystal, the attenuation of resonance is caused by internal friction in the crystal. In a volume electromagnetic resonator, it is lost in the walls of the resonator, in its material, and in communication components. In an optical resonator, it is lost on the reflection mirror.


For a series resonant circuit in an RLC circuit, where all three components are connected in series:

news-107-58


Among them, R, L, and C are resonant circuits of resistors, inductors, and capacitors.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry