Simple Series Resonant Circuit

Sep 26, 2025 Leave a message

Similar effects can also occur in series inductor/capacitor circuits. When reaching resonance state (capacitance reactance and inductance reactance are equal), the two impedances cancel each other out, and the total impedance drops to zero!


Example:

news-227-178

Simple series resonant circuit

 

news-340-168


At a resonant frequency of 159.155 Hz, the total series impedance is equal to 0 Ω, resulting in a short circuit at both ends of the AC power supply during resonance. In the circuit drawn above, this is not good. I will add a small resistor in series with the capacitor and inductor (as shown in the figure below) to limit the maximum circuit current and perform another SPICE analysis within the same frequency range.

news-247-180


Series resonant (also known as series variable frequency resonant) circuit suitable for SPICE

news-272-294

Series resonant circuit diagram of current I (v1)


As before, the amplitude of the circuit current increases from bottom to top, while the frequency increases from left to right. It can still be seen that the peak is located at the plotted frequency point of 157.9 Hz, which is the closest analysis point to our predicted resonance point of 159.155 Hz. This indicates that our resonant frequency formula is equally applicable to both simple series LC circuits and simple parallel LC circuits, as follows:

news-189-75


Caution should be exercised when using a series LC resonant circuit: Due to the possibility of high currents in the series LC circuit during resonance, dangerous high voltage drops may occur across capacitors and inductors, as each component has a significant impedance. We can edit the SPICE netlist in the above example to include voltage curves across capacitors and inductors to demonstrate what is happening.

 

87


The expected voltage for capacitors and inductors is 100V. This voltage will apply pressure to these components to this level, so they must be rated accordingly. However, these voltages are out of phase and cancel out, resulting in a total voltage of only 1V applied across all three components. The ratio of capacitor (or inductor) voltage to applied voltage is the "Q" factor.

news-278-63


Summary:


When the power frequency approaches resonance, the total impedance of the series LC circuit approaches zero.


The same formula for determining the resonant frequency in a simple series resonant circuit also applies to simple series circuits.


Due to the high current flow and significant impedance of individual components, resonance can generate extremely high voltages on individual components of a series LC circuit.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry