What Safety Preparations Need To Be Made Before Testing The Transformer Characteristic Test Bench

Sep 16, 2025 Leave a message

The transformer characteristic test bench under UHV power can help many power workers conduct various power tests more conveniently. safety preparation before using a transformer test bench is crucial

 

220

 

1.Power Off, Verify Power Off, Discharge, and Ground:

Complete Power Disconnection: Fully isolate the transformer under test from the power grid, disconnecting all electrical connections on both the high and low voltage sides (including neutral lines, bushings, etc.). Strictly follow electrical safety procedures: "power off, verify power off, and ground."

Reliable Verification: Use a qualified voltage tester (high-voltage验电笔) to confirm that there is no power at each terminal of the transformer.

Adequate Discharge: Fully discharge the transformer windings (especially high-voltage windings) and bushings. Transformers act like large capacitors and can store dangerous levels of charge. Use a dedicated discharge rod to discharge through a resistor first, then perform a direct short-circuit discharge.

Hang Grounding Wires: Reliably hang temporary grounding wires on the high and low voltage terminals of the transformer to prevent accidental power restoration. During testing, if wiring needs to be changed, the winding under test must be discharged and grounded first.

 

2.Isolation and Warning:

Set Up Barriers/Warning Lines: Erect clear warning lines or barriers around the test area and hang signs such as "Stop, High Voltage Danger!" or "Testing in Progress."

Designated Supervision: Assign a dedicated person to supervise the site and prevent unauthorized personnel from entering the test area.

 

3.Personal Protection:

Wear PPE: Operators must wear insulated gloves, insulated shoes, safety helmets, long-sleeved work uniforms, and other personal protective equipment.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry