Power frequency withstand voltage, also known as AC withstand voltage, is a practical and commonly used withstand voltage test in preventive testing. Doing power frequency withstand voltage is beneficial for testing the durability and prevention of cables and transformers. The best choice for withstand voltage testing is to use high-voltage test transformers and variable frequency series resonance.
The power frequency withstand voltage test device is a basic testing device for power stations, power supply systems, and scientific research institutions. It is used to test the insulation strength of various electrical products, electrical components, insulation materials at specified voltages, discover insulation levels, test insulation defects of items, and measure the ability to measure overvoltage.
The AC withstand voltage test of variable frequency series resonance is a destructive test. Before testing, the product must first be tested for insulation resistance, absorption rate, leakage current, and dielectric loss angle. If the test results are normal, the Jialou withstand voltage test can be conducted. If the insulation condition of the equipment is found to be poor, it is usually treated first by conducting a voltage withstand test to avoid excessive insulation breakdown.
The voltage, waveform, frequency, and distribution of the insulation internal voltage of the test object during the AC withstand voltage test are consistent with actual operation. However, the applied test voltage is much higher than the working voltage, which inevitably leads to severe operating conditions to check the insulation level of the equipment, thus effectively detecting insulation defects.
After the communication withstand voltage test is completed. After the voltage drops and the power is cut off, the remaining charge in the sample automatically reverses and discharges to ground through the high-voltage winding of the test transformer. For high-voltage lines that need to be replaced, more manual wire changing operations are required. In order to prevent accidental calls from the power side isolation switch or contactor and other unexpected situations, the terminals should be hung on the sample when replacing the wiring. Before re lifting, the discharge rod should be removed to prevent the use of a grounded discharge rod for boosting.





