Testing earth resistance with a Megger involves using an insulation resistance tester (Megger) to measure the resistance
between the grounding system and the earth. Here are the general steps for conducting an earth resistance test with a Megger:
Equipment Needed:
Megger (Insulation resistance tester)
Test leads with appropriate probes
Earth electrodes (current and potential electrodes)
Procedure:
Select Earth Resistance Measurement Mode:
Turn the Megger to the "Earth Resistance" or "Ground Resistance" mode. This mode is specifically designed for measuring the
resistance between the grounding system and the earth.
Connect the Test Leads:
Connect the test leads to the appropriate terminals on the Megger. Typically, there are separate terminals for the current (C) and
potential (P) connections.
Connect the Test Probes or Electrodes:
Connect the test probes or electrodes to the test leads. The setup usually involves three electrodes: one as the current electrode
(C) and two as potential electrodes (P1 and P2).
Drive the Current Electrode into the Ground:
Drive the current electrode into the ground at the location where you want to measure the earth resistance. This electrode is
used to inject a known test current into the ground.
Place the Potential Electrodes:
Place the potential electrodes (P1 and P2) at a specified distance from the current electrode to form a triangle. The distance
between the potential electrodes is important for accurate measurements.
Apply Test Current:
Activate the Megger to apply a known test current through the current electrode into the ground.
Measure Voltage Drop:
Measure the voltage drop across the potential electrodes (P1 and P2). This voltage drop is caused by the test current flowing
through the ground.
Calculate Earth Resistance:
Use Ohm's Law (Resistance = Voltage / Current) to calculate the earth resistance. The formula is often represented as R = (V / I),
where R is resistance, V is voltage, and I is current.
Interpret the Reading:
The Megger will display the calculated earth resistance value. Compare the result with acceptable limits specified by relevant
standards or regulations.
Record the Measurement:
Record the earth resistance measurement along with information about the test setup, conditions, and location.
Important Considerations:
Follow safety procedures to ensure that the grounding system is disconnected from the electrical system during the test.
Wet the soil around the electrodes if the soil is dry to improve electrical contact.
Ensure that the distance between the potential electrodes is appropriate for the test method being used.
Always refer to the user manual provided by the Megger manufacturer for detailed instructions and guidelines specific to your
instrument. Additionally, adhere to local standards and regulations governing earth resistance testing.




